HOW TO
APPLY
Easy to apply.
Built to last.
Premium golf shaft wraps designed for a smooth application and a flawless finish that lasts round after round.
HOW TO
APPLY
Easy to apply.
Built to last.
Premium golf shaft wraps designed for a smooth application and a flawless finish that lasts round after round.
Watch Once. Apply With Confidence.
A clean install starts with the right prep, alignment, and finish. The quick video below walks you through the process step by step.
Step-by-Step Application
Read all steps before starting. The wrap is tapered: apply the wider end at the top near the grip and the narrower end at the bottom near the ferrule. The entire process should take less than ten minutes.
Initial Prep
Gather your tools:
Wipe the shaft with a clean, dry paper towel to remove any dirt or residue.
Lay the wrap flat on a table and place your club on top of it. The narrow end should be toward the bottom near the ferrule.
Align & Mark
Slide the wrap back and forth to position the pattern exactly how you want it to appear on the shaft.
Mark the wrap with a pen at the ferrule and near the grip, leaving a little extra so you can trim later to perfection.
Cut & Remeasure
Cut straight across at both marked spots.
Check again to see if you need to trim at either end for a perfect fit.
Remark and cut any excess wrap around the grip area.
Peel & Position
Peel off the entire backing from the wrap. Be careful not to let the wrap fold onto itself.
Position the wrap with the wide end at the top and the narrow end at the bottom. Align the center of the wrap with the center of the shaft.
Using a paper towel, press the center of the wrap firmly onto the shaft using long strokes up and down until it adheres securely.
Next, adhere the side without the logo using the same long stroking method. Then adhere the other side. A small overlap is normal.
Smooth & Adhere
Using a paper towel, press the center of the wrap firmly onto the shaft using long strokes up and down until it adheres securely.
Next, adhere the side without the logo using the same long stroking method.
Then adhere the other side. A small overlap is normal.
Play Bold!
You're all done. No cure time is required.
Enjoy the new look of your clubs and get back on the course immediately.
Dare to Play Bold.